1.5
Protective Glass
Protective glass is made of transparent acryl (PMMA) to pass through laser beam with maximum
efficiency. In addition, it blocks external dust or resin from penetrating inside the device.
For the best printing performance, it is very important that the protective glass is not scratched or
contaminated. If glass is damaged or contaminated, laser beam may be cut off or diffused, so that
print quality degradation or printing failure may occur.
In case of print quality issue or printing failure, check the status of protective glass and clean it if
necessary.
Wear clean nitril gloves before starting cleaning.
Removing platform
Remove platform because resin or other contaminants can be dropped from it.
Open orange cover, and remove two platform locking knobs to take out the platform from the device.
Removing resin tank
Take out resin tank by unlocking handles.
If resin is still filled in the resin tank, be careful not to drop or splash resin when you remove resin from
the resin tank or try to move the resin tank.
2
1
5
Maintenance
Summary of Contents for A1 Series
