9
In order to ensure the air convection, please refer to Figure 2-1, around the servo drive with enough space.
In order not to make the ambient temperature of the servo drive partial excessive phenomenon, so that to maintain a uniform temperature of
electric cabinet, please install cooling fan above servo drive in electric cabinet.
2.4.3 Ground
Make sure the ground terminal is grounded, otherwise, there may be a risk of electric shock or interference arising from false action.
Figure 2-1 Servo Drive Installation Direction and Space
2.5 Servo Motor Installation Direction and Space
2.5.1 Motor installation
SER series servo motor must be installed in a dry and solid platform, please keep good ventilation and heat radiation effect, and keep a
good grounding.
2.5.2 Installation diagram
Item
Description
Anti-rust
solution
Wipe clean servo motor shaft extension ends of the "anti rust agent" before
installation, and then do the relevant anti rust treatment
Encoder note
Installation to prohibit the impact of the shaft extension end, otherwise it
will cause internal encoder fragmentation.
Pulley
installation
When installing the pulleys in the servo motor shaft with keyway ,please
use screw on the shaft end. In order to install pulley, at first, the double
headed nail is inserted into the screw hole of the shaft, washer is used on
the surface of the coupling end and a nut gradually locked into the
pulley.
About the servo motor shaft with keyway, use the screw holes of shaft
end to install. About the shaft of no keyway, adopt the wear coupling or
similar method.
When removing the pulley, adopt pulley removal device to prevent shaft
subjected to impact.
In order to ensure safety, a protective cover or similar device shall be
installed in the rotating area.