INSTALLATION
INPUTS
11
The input load is 48K
Ω
, and its sensitivity is adjustable from 400 mV peak - peak (150 mV RMS)
to 8V peak - peak (2.8V RMS), therefore it perfectly matches any source, including those that provide a
4V pre out (1.4V RMS). The regulation is achieved rotating the input R and L potentiometers with a common
screwdriver. In order to obtain the BRIDGED MONO operation it is necessary to use a Y cable to reach the
two inputs, while in the simultaneous MONO-STEREO connection the use a passive low-pass filter before
the subwoofer is necessary. This will shield it from the high and medium frequencies, that are present in
stereophonic mode.
Summary of Contents for Tempo Allegro
