WINDING THE BOBBIN
You will find a bobbin in place under the slide
plate of your machine. (To open slide plate,
simply draw it gently toward you.) If the bobbin
runs out of thread during sewing, you can re
wind it without removing it from the machine.
The window in the slide plate lets you see
bobbin-thread supply at a glance, to help
avoid running out of thread in the middle of
a seam.
Preparation Steps
1. Raise the take-up lever to its highest posi
tion by pressing lightly on the speed con
troller or by turning the hand wheel toward
you.
2. Raise the presser foot to release tension
discs.
3. Open slide plate and make sure bobbin is
empty. For removal of bobbin and thread,
see page 12.
4. Set pattern-selector release lever by turn
ing it clockwise, see page 14, and set stitch
control dials for straight stitching; stitch
pattern I , needle position/^(center)
and stitch w i d t h .
If pattern-selector release lever fails to lock
into place, turn the hand wheel slightly toward
you and then reset lever.
Winding Steps
1. Move bobbin latch to right (wind position).
2. Draw needle thread back between toes of
presser foot, under left side of presser foot,
then up, into and around thread retainer, as
shown. Do not hold thread end. Start the
machine, running it at a moderate speed.
3. Pull thread end away after it has separated
from bobbin.
• Keep your eye on the bobbin as it fills.
Do not allow thread to wind beyond the
outside FULL ring.
4. Close slide plate to release bobbin latch to
sewing position.
To start sewing, pull thread back under
presser foot and cut. Place threads diagonally
under foot to right or left side, position needle
in fabric where desired, lower presser foot,
and start machine.
Winding Steps
Step 4
11
Instrukcje obsługi maszyn do szycia firm Polskich jak i zagranicznych np. Singer Toyota Pfaff Gritzner Łucznik Arka
