Singer SGR-18300, Instruction Manual

8

ENGLISH

NOTE: Do not use chemical, steel, wooden or abrasive cleaners to scrape 
the soleplate.

2.  Clean the upper part of iron with a soft damp cloth. Wipe the water drop on 

the steam generator and the thermal insulating cushion with dry cloth.

3.  To not damage the soleplate, we advise you never put the soleplate on a 

metal surface. Clean your steam generator after every 10 times of use.

4.  When do not use the appliance for a long time, pour out the water in the 

tank, and store the iron on the thermal insulating cushion.

5. Wind the iron cord and power cord around the cord winding groove. 

Type of water to use

You can use normal tap water to 

fi

 ll the tank. Therefore, especially if your tap 

water is very hard, we advise you to mix it with distilled water or use distilled 
water only. We advise you to empty the water tank after use.
 Do not add anything to the contents of the boiler and do not use water from 
clothes dryers, scented or softened water, water from refrigerators, batteries, 
air conditioners and rain water. These contain organic waste or mineral 
elements that become concentrated when heated and cause brown staining 
or premature wear to the steam generator. Use of these types of water will 
negate the guarantee provided with the product.

REDUCE LIMESCALE 

In order to improve the effectiveness of steam and prolong the boiler life of your 
product, you can reduce the formation of limescale by using the household 
descale for cleaning steam generators SINGER CALC OUT (follow directions 
on the packaging).
You can 

fi

 nd SINGER CALC OUT in authorized SINGER service centers.

IRONING TIPS

-  Always check 

fi

 rst whether a label with ironing instructions is attached to the 

article. Follow these ironing instructions in any case.

-  The iron heats up quicker than cooling down; therefore, you should start 

ironing the articles requiring the lowest temperature such as those made of 
synthetic 

fi

 ber. 

-  If the fabric consists of various kinds of 

fi

 bers, you must always select the 

lowest ironing temperature to iron the composition of those 

fi

 bers.