35
troubleshooting
troubleshooting of Washer
List of faults and corrective actions
faults
Corrective actions
No water
flows in to
the washing
machine
if the power is off or the fuse is burned out.
if the water supply is cut off or the water pressure is too low
if the inlet hose is not properly connected and the water tap is opened.
if the filtering screen of the inlet value is blocked by dirt.
if the inlet value is malfunctioned (The slight electromagnetic sound is a normal
phenomenon when the inlet value is switched on)
if the “Start / Pause” button is pressed after the power switch is pressed.
No washing
operation is
taking place
if the power is off or the fuse is burned out.
if the power support voltage is too low.
if the water amount not reached to the required water level. (The washer will not work
if the water amount does not reach the required water level)
if it is set to “Delay” washing mode. (It will only start to work until the reservation time
is reached.)
No water
draining out
if the water drain hose is placed very high.
if the end of water drain hose is sealed in pond or gully.
if the internal rubber ring of the drain value is blocked by dirt
No spinning
or abnormal
noise
if the door lid is closed.
if the clothes are gathered largely at one side of tub or the load of clothes is
excessive.
if the washer is not placed in a stable condition or it is placed in an inclination state.
(The ground is not fat or levelling leg).
if the motor belt is loose.
The power is
cut off.
Is the electric voltage normal?
Is the washer plugged in? Plug in the electric cord.
The water
drains out
continuously.
The drain is clogged with coins or pins.
Water does
not drain
The drain hose is hung over the drain hose hook.
Water leaks
at the water
supply side
If the faucet connection is loose, water may leak.
Check if the rubber packing of the water supply hose is in the right position.
Is the water supply hose damaged?
If the water supply is too strong, water may leak.
Is water leaking from the faucet itself?
note :
During the spinning process, if the clothes are piled at one side of the
spin tub, it will be result in the spin tub being unbalanced and may lead to
the tub striking the cabinet. When this happens, the machine will immediately
detect and correct the imbalance up to three times. If the imbalance is not
resolved by the auto-correction feature of the machine, the user has to
manually re-distribute the clothes inside the tub to solve the problem.
Summary of Contents for SISIL SL-RFA75
Page 1: ...WASHING MACHINE USER MANUAL SWM FA70R SWM WSFR7 SL SWMFR72 SWM FAR75 SL RFA75 SWM FATL7R BB...
Page 37: ......
Page 38: ......
