20
BeatBuddy Manual
Settings
•
Unpause
Behavior
-
Sets what happens when the
BeatBuddy is unpaused.
o
Main Pedal Unpause - Sets what happens if the Main Pedal is pressed
while the BeatBuddy is paused.
Note: If Start Beat is set to Press, the
unpause behavior will only be allowed to be set on the Tap. This is to avoid
unwanted actions occurring on the tap while paused.
•
Tap - While paused and the main pedal is tapped (pressed
quickly).
o
Intro
o
Fill*
o
Start Transition
o
Stop Song
•
Hold
- While paused and the main pedal is held down. (Please
Note: This
function will not work if Start Beat setting [read below]
is set to Press)
o
Stop Song*
o
Start Transition
o
External Unpause - Sets what happens when an external device sends a
command to the BeatBuddy from a paused state.
•
MIDI Settings
of this manual “MIDI and the
BeatBuddy”
•
Cue Fill Period -
Controls when the fill is triggered after the pedal is pressed.
Please note that even when set on 'Immediately', if you press the pedal in the
last half beat of the measure, it will play the fill in the next measure, because it's
very unlikely that you want less than a half beat fill, so you probably pressed it
too early.
o
Immediately
*
o
Next Half Beat
o
Next Beat
o
Next Measure
•
Start Beat -
Controls whether to start the beat on the press of the pedal or
release. Press is more immediate, but if you set it to Press, you cannot use the
Hold pedal features (enter tap tempo from Stopped mode, stop song or start
transition from paused mode).
Note: If Start Beat is set to Press, then the Main
Pedal Unpause sub-setting, Hold, will not be available and hold commands will
behave as expected in the case hold is detected.
o
Press*/Release
•
Visual Metronome
- Sets when the Visual Metronome (the moving bar on the
screen) is active.
o
Stopped & Playing*
o
Playing Only
o
Disable
