31
BeatBuddy Manual
MIDI and the BeatBuddy
•
N
ext Part (CC:102)
o
When enabled, the BeatBuddy sends out the CC:102 MIDI command when
the transition has completed and the next part starts. If disabled, the
BeatBuddy does not send out the CC:102 command. Some devices (such
as
the Eventide Timeline) get confused when they receive this command
and
do not operate properly. This command is required for song part
control
with the Aeros when BeatBuddy is triggering part changes.
•
Enable
*
/Disable
•
Time Signature
o
When enabled, BeatBuddy sends out Time Signature information when
the
BeatBuddy song loads and at every 1 of the measure after opening the
song. This is useful for the Aeros Loop Studio so that it can sync the
internal time signature with the BeatBuddy's even as the time signature
changes. The Aeros can only change time signature
before
recording.
o
If disabled, the BeatBuddy does not send out the Time Signature
information. Some devices get confused and don't operate properly when
they receive this signal.
•
Enable
*
/Disable
o
Remember, t
ime Signature is sent by BeatBuddy whenever a song is
loaded as a Sysex midi message
and at the 1 of every measure after
opening the song
.
•
all values in hex
o
2/4: F0 - 7F - 7F - 03 - 02 - 04 - 02 - 02 - 18 - 08 - F7
o
3/4: F0 - 7F - 7F - 03 - 02 - 04 - 03 - 02 - 18 - 08 - F7
o
4/4: F0 - 7F - 7F - 03 - 02 - 04 - 04 - 02 - 18 - 08 - F7
o
5/4: F0 - 7F - 7F - 03 - 02 - 04 - 05 - 02 - 18 - 08 - F7
o
3/8: F0 - 7F - 7F - 03 - 02 - 04 - 03 - 03 - 18 - 08 - F7
o
6/8: F0 - 7F - 7F - 03 - 02 - 04 - 06 - 03 - 18 - 08 - F7
Restore MIDI Settings - Resets all MIDI settings to default
o
Yes/No
