ARC AUDIO MOTO 600.4
1.
Remove the fuse from the SinisterSound power and ground cable.
2.
Connect the SinisterSound power and ground cable to the amplifier and route towards
the battery through the cable channel under the tank.
3.
Connect the RCA harness to the amplifier Input port and the RCA’s to the output ports of
the head unit. Connect the remote turn on wire to the head unit wiring harness.
4.
Connect the speaker pod wires to the CH1 and CH2 output ports on the amplifier.
5.
Change the amplifier settings as shown in the table below.
6.
Connect the power and ground cable to the battery
7.
Insert the fuse on the power and ground cable.
8.
Continue to the Testing and Tuning section.
Arc Audio Moto 600.4 Amplifier Settings
Moto 600.4 Front
Moto 600.4 Top
1. Set load select to 4
Ω
Stereo.
1. Set Input to 2CH
2. Set Auto Sense to OFF
3. Set Bass Boost to B
4. Set FREQ Hz to 100
5. Set to High Pass
6. Set Gain to Min (This is a Starting Point)
1.
2.
4.
3.
5. 6.
1.
P A G E
!
O F
!
9
1 4
R E V 0 0 1
Front
