sinmag HS-3, Owner'S Manual

INSTALLATION AND COMMISSIONING    

3

Installation 

After uncrating your horizontal slicer, inspect the machine for any damage 

that might have occurred during shipment. Report any damage to us before 

proceeding to operate this machine. Never attempt to operate this machine 

with damaged parts. 

 
Select a location for the machine to allow sufficient room for operarion, 

cleaning and servicing. The floor should be solid and level. The machine is 

fitted with 4 casters to facilitate its installation and handling. Ensure that the 

casters are properly locked to ensure good machine stability at the 

workplace. 

 
Before making any electric connection, be sure that your electric mains is 

compatible with the electric specifications of your slicer. This data is shown 

on your machine nameplate. Then ask an authorized electrician to connect 

the machine with the power supply with a grounding protection.   

Commissioning 

Before operating, please press the blade to check if its tension degree is 

appropriate. See the picture 1, turn the knob to adjust the blade to a proper 

tension. 

 
Switch on the machine to see if the conveyor belt is slipping. See picture 2, 

adjust the screw to give the belt a proper tension. 

Picture 1                                Picture 2 

Knob

Screw