B. Smooth R
17
This determines the position of the first cut feed in the processing of circular arc.
As show in Fig.(b), the start angle is 0° if the arc is to be processed from Point E
to Point F, and 90° when from F to E.
8. Enter the end angle of the arc
(ED ANG)
This determines the position of the last cut feed in the processing of circular arc.
As shown in Fig. (b), the end angle is 90° if the arc is to be processed from Point E
to Point F, but 0 when from F to E.
9. Determine inner/outer circle mode:
For outer circular arc, as shown in Fig. (b), RAD+TL.
For inner circular arc, as shown in Fig. (c), RAD -TL.
10. Move the machine tool to the start point of the processing in
following with the display on axes, and then start the point by point
processing.
11. You can quit the Arc R Calculation function as will, just key .
(
Ⅰ
) *Take the processing of the arc shown in the figure in page 22 as an
example.
1) At first, finish tool setting, reset, key ,
and enter ARC function.
2)choose smooth function
press
press
3) Select processing plane
Key
or
4) Select Plane XY
Key
5) Enter the position of the circle center.
If finish the tool setting as shown in Fig. (a).
Key
Key
2
4
5
2
2
5
X
R
R
Summary of Contents for SDS2MS
Page 4: ...Illustration of Panel and Keyboard 1...
Page 21: ...B Smooth R 13 B Smooth R Iran agent Tel 021 66 3939 00 Mob 0912 147 3023 www Sino ir...
Page 30: ...C Simple R 22 C Simple R Iran agent Tel 021 66 3939 00 Mob 0912 147 3023 www Sino ir...
Page 65: ...J N3 Function 57 J N3 Function Iran agent Tel 021 66 3939 00 Mob 0912 147 3023 www Sino ir...
