C. Simple R
24
Fig. (a)
MA
X
CU
T
Fig. (b)
MAX CUT
R1
0
B
φ5
A
2. Select the processing way among the preset 1 to 8 ways, the prompt:
“WHICH”.
3. Select the processing plane, XY
、
XZ or YZ.
(ARC-XY)
(ARC-XZ)
(ARC-YZ)
4. Enter the of the circular arc (RDDIUS)
5. Enter the diameter of the tool (TL DLA): When processing the arc in Planes XZ
and YZ, end mill is used and the processing in carried by the end edge of the
tool, so the diameter valve to be entered should be zero.(refer to step 5 in the
operation procedure of the smooth R function).
6. Enter the maximal cut (MAX CUT):
When processing an arc in Planes XZ
and YZ, “MAX CUT” in the simple R
function is defined as the depth of cut
in each cut feed in Z axis direction
(see Fig. a) the maximal cut can be
changed during the processing.
When processing an arc in plane XY,
“
MAX CUT
”
is the cut of each cut feed and is uniform (refer to Fig. b).
7. Implement the processing point by point following the display.
8. You may quit the arc R Calculating
function at will, just key .
*Take the processing of the arc on
right as an example.
1) At first, let the tool face just at the start point of
the arc (point A or Point B), key ,
enter ARC function.
Select the simple function key .
2) Select R processing mode.
Start point is A, key
End point is B, key
R
R
4
3
Summary of Contents for SDS2MS
Page 4: ...Illustration of Panel and Keyboard 1...
Page 21: ...B Smooth R 13 B Smooth R Iran agent Tel 021 66 3939 00 Mob 0912 147 3023 www Sino ir...
Page 30: ...C Simple R 22 C Simple R Iran agent Tel 021 66 3939 00 Mob 0912 147 3023 www Sino ir...
Page 65: ...J N3 Function 57 J N3 Function Iran agent Tel 021 66 3939 00 Mob 0912 147 3023 www Sino ir...
