E
.
The Function For 200 Point
34
200 subsidiary zero position function:
200 auxiliary zero position function: also is called 200 user Coordinate
System (UCS) function.
ALE: Absolute Coordinate System.
ALE is the “reference” system. All 200 UCS are defined relative to the ALE.
ALE is confirmed in the initialization of the work piece process, which doesn’t
change if the work piece no changed.
UCS: User Coordinate System.
In the processing of moulds, often it would not work with only one reference
zero position, normally, a lot of subsidiary zero positions is necessary. In the
processing of a large of complicated drilling/milling fittings with multi point
dimensions, it is also necessary to have a lot of fixed point positions in order to
perform the processing of a series of structures with dimensions referred to these
point position. In these cases, if there is only one reference point, the working
efficiency will be rather low, as you have to find out the correct position point by
point, more over, it may be very difficult for complicated moulds or moulding
fittings to do in such a way. The function 200 point subsidiary zero positions is
specially provided as a good resolution for this problem.
Ⅰ
. The operator must know the following two key points before
making use of this function:
1. Every subsidiary zero position is equivalently the original point of one
UCS. Once entering the display mode of such UCS, the display of every
point will take the subsidiary zero position as the original point.
2. There is relation between every subsidiary zero position and the zero
position is the absolute mode. After a subsidiary zero position is set, it will
keep the position relation between it and the zero position in the absolute
mode in memory, once the zero position in the absolute mode changes, the
subsidiary zero position will also change by the same distance and angle.
Ⅱ
. The operator may fully make use this function as the
following:
1. Set the zero position in absolute mode (ALE lamp on) at the main reference
point of the working piece, for example, Point O in Fig. (1) in next page. Set
subsidiary zero positions at subsidiary reference points of the working piece, for
example, Points 1, 2 and 3 in Fig. (1). It is possible to enter the display mode of
Summary of Contents for SDS2MS
Page 4: ...Illustration of Panel and Keyboard 1...
Page 21: ...B Smooth R 13 B Smooth R Iran agent Tel 021 66 3939 00 Mob 0912 147 3023 www Sino ir...
Page 30: ...C Simple R 22 C Simple R Iran agent Tel 021 66 3939 00 Mob 0912 147 3023 www Sino ir...
Page 65: ...J N3 Function 57 J N3 Function Iran agent Tel 021 66 3939 00 Mob 0912 147 3023 www Sino ir...
