E
2
. The Function For 200 Point(Be the same with:
LATHE)
48
200 subsidiary zero position function:
200 auxiliary zero position function: also is called 200 user Coordinate
System(UCS) function.
ALE: Absolute Coordinate System.
ALE is the “reference” system. All 200 UCS are defined relative to the ALE.
ALE is confirmed in the initialization of the work piece process, which doesn’t
change if the work piece no changed.
UCS: User Coordinate System.
In the processing of moulds, often it would not work with only one reference
zero position, normally, a lot of subsidiary zero positions is necessary. In the
processing of a large or medium lot of complicated drilling/milling fittings with
multi point dimensions, it is also necessary to have a lot of fixed point positions in
order to perform the processing of a series of structures with dimensions referred
to these point position. In these cases, if there is only one reference point, the
working efficiency will be rather low, as you have to find out the correct position
point by point, more over, it may be very difficult for complicated moulds or
molding fittings to do in such a way. The function 200 point subsidiary zero
positions is specially provided as a good resolution for this problem.
Ⅰ
. The operator must know the following two key points before
making use of this function.
1. Every subsidiary zero position is equivalently the original point of one UCS.
Once entering the display mode of such UCS, the display of every point will
take the subsidiary zero position as the original point.
2. There is relation between every subsidiary zero position and the zero position is
the absolute mode. After a subsidiary zero position is set, it will keep the
position relation between it and the zero position in the absolute mode in
memory, once the zero position in the absolute mode changes, the subsidiary
zero position will also change by the same distance and angle.
Ⅱ
. The operator may fully make use this function as the
following:
1. Set the zero position in absolute mode (ALE lamp on) at the main reference
point of the working piece, for example, Point O in Fig. (1) in next page. Set
subsidiary zero positions at subsidiary reference points of the working piece, for
Summary of Contents for SDS6
