E
2
. The Function For 200 Point(Be the same with:
LATHE)
51
Why the direction of each coordinate of your input auxiliary zero position
opposite to that of the display result? As the above example illustrates, under the
user coordinate display mode, if your enter the coordinate of auxiliary zero
position on the position of the zero position under absolute state, the display result
will be the position of absolute state zero position in this user coordinate. Because
the user coordinate display mode uses each auxiliary zero position as the origin of
user coordinate. Seeing from Fig. 1, Point O is exactly located at the position of
Point 1(-20, 70), the position of Point 2 (-30, 120) and that of to Point 3 (-20, 130).
If the operator enters the coordinate of auxiliary zero point at any other point than
the zero point under absolute state, the display result will be the position of this
point in this user coordinate.
Method 2: Clearing when the position is reached. When the machine tool is at
the position of the subsidiary zero point, key .
Method 2 is not suited to operations on lathe. The instructions for lathe are
not given in details in this manual.
Ⅳ
. The usage of subsidiary zero positions.
After entering the display mode of the UCS, the corresponding subsidiary
zero positions may be used to help in the processing.
It is possible to enter a UCS display mode using key
、
or .
When using keys and , you may key or continuously until
entering the desired UCS.
When using key just key and under the prompt “ZERO No” enter the
number of the desired UCS. For the related operations, the operator may refer to
“5 Absolute/relative/user coordinate display mode” under “
Ⅰ
.Usage” of “A. Basic
Function”.
Take the spare part shown in Processing Fig. (2) as an example, operator can
use the 200 point auxiliary zero-point function in grinding and turning.
Summary of Contents for SDS6
