Sinocare Safe AQ UG, User Manual

Setting Up Your Safe AQ UG Blood Glucose and Uric Acid meter

Setup steps for date/time 

The Safe AQ UG blood glucose and uric acid meter is preset with the date and time. You may 

need to adjust it to your local time zone. Check the date and time each time the batteries are 

replaced. Reset the date and time if they are not correct.

STEP 1

: Insert the Batteries 

Open the Battery Cover on the back side of the Safe AQ UG blood glucose and uric acid 
meter. Insert two AAA alkaline batteries as indicated by the “+” and “-” symbols. 

STEP 2

: Set Correcting Code of Uric Acid (use code chip)

Code chip matching with test strips shall be used when you use a new vial of uric acid test 

strip. Find code chip in test strip package, check if the code number on code chip is in 

accordance with code number on test strip package. If not, you will get inaccurate test 
results, please call Customer Service at +86-731-8986-731-89935582. If there is 
already a code chip in Safe AQ UG meter, please take it out and insert a new code chip. 
Insert the code chip to code chip port, the meter will make a short beep sound and perform 

self-inspection. The meter will display code number and meter will be off after a short beep 

11

12

sound. 

If there is an error, the meter will display E-4. Please pull out the code chip and insert again. If 

still failed, please call Customer Service at +86-731-8986-731-89935582. 

Every code chip only need to be inserted once, the meter will store the code number until 

insert new code chip.

STEP 3

: How to Set the Date and Time 

1. With the meters off, press and hold ▼for 3 

seconds and the meter will turn on. The meter 

enters into the Date/Time mode.

2. It displays date and time, the segment of 

year flashes. 

Step 1:

With the meter turned off, 

press and hold ▼ for 3 

seconds to start Time and 

Date setting mode.

Step 2:

Date/Time Mode 

Flashing Year

STEP 4

: Setting the Year

The year appears flashing at the left side of the 

meter display.  

1. Press and release ▼or▲ button to decrease 

or increase the year. 

2. Short press and release the main button     

to confirm the year.

Step 1:

Press and release ▼ or ▲ 

to decrease or increase the 

year.

Step 2:

Short press and release the 

main button     to confirm 

the year.