Agriculture Drone User manual
Agriculture Drone User manual
(1). Electric Speed Control(ESC) Calibration
The drone has been calibrated when it leaves factory, but if the motor speed is
obviously inconsistent during the later flight, please calibrate the drone again as follows:
Step1:
Power on the drone and push throttle joystick to top, then LED indicates the
current GPS status and flight mode
Step2:
Toggle SD quickly for 6-10 times from top to bottom until LED light up in RED.
Step3:
Hold the throttle joystick, plug drone power off and then power on, the LED
will flash once in turn of RED, GREEN and BLUE.
Step4:
After power on for about 0.5 seconds, the drone will “DiDi” sound twice.
pleasepull the throttle joystick to bottom in 2 seconds,and drone will
“DiDi”sound twice again. LED will flash in RED and Blue normal status.
Operation diagram:
7. Drone Calibration Instruction
throttle
joystick to top
toggle SD
for 6-10 time
hold Joystick,
cut off and
power on
joystick to
bottom
after "Di" for
twice
LED Indicates
GPS status and
flight mode
(2).Horizon Level Calibration
The drone has been calibrated when it leaves factory, if it tilts seriously towards
certain direction during later flight, please calibrate the drone again as follows:
Step1
：
Put the drone on horizontal ground, make sure it doesn't shake.
Step2
：
Lock the drone by holding the joysticks like second diagram for 10 seconds
until LED flash alternately in BLUE and GREEN.
Step3
：
Release the joysticks, LED will flash in BLUE about 10 seconds later, and
then LED will flash normally after 15 seconds.
Operation diagram
：
Horizontally land
LED Indicates
GPS status and
flight mode
Lock the drone
Release the
joysticks
Flash
normally
(3).Compass Calibration
Compass calibration is required when the aircraft takes off first time or changes
location (50KM
from the last flight position). The calibration method is as follows:
Step1
：
pull throttle joystick to bottom.
Step2
：
Toggle SD quickly for 6-10 times from top to bottom until LED light up in BLUE.
Step3
：
Place the drone head facing forward horizontally, slowly turn the drone
clockwise at least one round
until the LED green light is on
Step4
：
Place the drone head down, fuselage vertical, and then slowly turn
clockwise at least one round until the LED light up in WHITE for 4 seconds.
If the LED light up in RED for 4 seconds, indicating calibration failure, repeat steps
2-4 until succeed.
Operation diagram
：
（4）
（4）
LED Indicates
GPS status and
flight mode
throttle
joystick
bottom
toggle SD
for 6-10 times
turn clockwise
ok
Fail
(1).Gesture mode
In gesture mode, without too much data to calculate, the drone respond fast but cannot
Hover at fixed-point, this mode is suitable for skilled pilot.
(2).GPS mode
With good GPS signal, the drone can hover at fixed-point in GPS mode.
(3).Spray mode
Spray mode is based on GPS mode, only with good gps signal, user can enter this mode.
operate method as follows:
8. Flight Mode Introduction
line change point
start point
Operating Interval
05
06
