Agriculture Drone User manual
Agriculture Drone User manual
Only when the GPS signal is good and return landing position has been record
before flight
starts (LED will flash 10 times in BLUE if recorded
(10) ), can the drone
receive return
command, method as follows:
Step1
：
Switch SC to RETURN position, the drone will automatically rise 1.5 meters and
hover, (will
not rise in gesture mode or GPS mode), and record the breaking point.
Step2
：
Toggle SC once and back to RETURN position, the drone will rise up 2 meters
and then return.
Step3
：
Restart the drone (refer to method of restart at pesticide breaking point). the drone
will automatically rise to the 2.5meter height and fly back to break point, and then
drop to the operating height. (user can pull throttle joystick to stop dropping)
10. Return Command
If remote control signal lost, LED will keep flash in YELLOW and BLUE
( ∞ ) ,
after hovering for 5 seconds, the drone will return to the take-off position, land and lock .
if the signal recovered during return flight, it will stop returning and switch back to RC
current
SD mode.
11 Out of Control Protection
During flight, battery voltage PWR will be displayed real-time on remote control
screen (display position as below configure). When drone battery voltage is lower than
43.5V, remote control will give voice and vibration alarm. The drone can last about 2
minutes at this time, please land the drone in time and replace batteries.
12. Low Voltage Alarm
P
WR
:
43
.
5V
6S Lipo Battery
设置/停
止
确认/开始
选项
设置/停止
选项
确认/开始
Battery Charging:
User shall charge battery when voltage is low. (input power AC100-240V)
Connect battery like below configure, connect power cable, press “start” 2 seconds
to charge. Once charging finished, it will show “charging finished” on screen, full voltage
should be around 25.2V.
If the batteries are not used for more than 10 days, user shall use “charge for
storage” mode to keep battery in a storage voltage.
13.Battery Charge
6S Lipo Battery
Unlock
Lock
Only one way available for locking and unlocking the drone. show as follows: pull
the throttle joystick for at least 3 seconds after the drone land, it will lock automatically.
and rotors will start one by one after unlocking.
14. Lock and Unlock the Drone
09
10
