10 | Sinterit POWDER SIEVE User Manual
F. WORKING WITH POWDERS
ATTENTION!
When working with the polyamide powder or other designated printer powder for
the Sinterit POWDER SIEVE always wear protective kit: glasses, gloves, dust mask
(e.g. you can use the “PERSONAL PROTECTION” set included with Lisa printers).
ATTENTION!
•
When working with a polyamide (PA) powder, avoid inhalation or swallowing and contact
with skin and eyes.
•
If the PA powder is inhaled, move to a place with fresh air and gargle thoroughly with plenty
of water. If coughing develops, contact a physician.
•
In case of swallowing PA powder, rinse your mouth with water and drink 1-3 glasses of water
to dilute stomach contents. Contact your doctor.
•
If the PA powder gets in your eyes, rinse them thoroughly with water. In case of persisting
eye irritation, contact a physician.
•
When the PA powder gets in contact with your skin, wash it with soap and water.
ATTENTION!
•
Polyamide powder should be stored in tightly closed containers, in a room at room
temperature and low humidity.
•
The powder should be stored out of reach of children and pets.
•
If the device is not used for a long time, the powder should be stored in a sealed package.
WARNING!
•
Fire and explosion hazard!
•
Do not attempt to burn/melt polyamide powder. The resulting sparks and hot
mass, the powder is converted into can cause severe burns.
•
Keep the polyamide powder away from fire.
STOP!
Do not dispose to municipal waste!
The used polyamide powder should be stored in sealed containers and disposed
of in accordance with local policy of waste plastic material.
G. SCRAPPING
IMPORTANT!
In case of scrapping, all the component parts of the powder sieve will have to be
disposed of through adequate disposal channels in accordance with applicable
legislation. Before scrapping, all plastic and rubber parts will have to be separated
from the electrical material. Parts made of plastic, aluminium and steel only may
be recycled if collected by special centres.
