occurred that prevents a module to answer, this
means that the address is not used in the system
(and not the addresses above either). Check that
the previous address was the highest in use.
Change PIN code
(Service Mode)
Press
Enter
to change the PIN code.
Numbers in the pin code are changed with the
arrow keys. When the new pin code has been
chosen, press
Enter
to confirm and store the new
code.
If the PIN code is lost, see
Reset pin code to
factory default
for advice.
Change IP-address
(Service Mode)
If the unit will be connected to Ethernet, the IP-
address may have to be changed from the default
192.168.0.234.
Press
Enter
to change the IP-address.
Numbers in the IP-address are changed with the
arrows. When the new address has been chosen,
press
Enter
to confirm and store the new address.
The module must be restarted (power off/on) to
effectuate the change.
Please note: if a direct connection between the
MIDI SMOKE 2 and a PC (Windows) is desired, it
will be necessary that the IP-address for the PC
and the MIDI SMOKE 2 shares the same network
address space. Typically this means that the first
three fields in the IP-address must be identical.
The last field must differ.
Either change the IP-address for the PC or the
MIDI SMOKE 2.
Change IP-gateway address
(Service Mode)
Introduced in firmware 1.40
If the unit will be connected to Ethernet, the IP-
gateway address can be changed to match the
current network.
Press
Enter
to change the IP-gateway address.
Numbers in the IP-gateway address are changed
with the arrows. When the new address has been
chosen, press
Enter
to confirm and store the new
address.
The module must be restarted (power off/on) to
effectuate the change.
Change subnet mask
(Service Mode)
Introduced in firmware 1.60
If the unit will be connected to Ethernet, the Subnet
Mask can be changed to match the current
network. Factory default setting is 255.255.255.0.
Press
Enter
to change the Subnet Mask.
Numbers in the Subnet Mask are changed with the
arrows. When the new address has been chosen,
press
Enter
to confirm and store the new address.
The module must be restarted (power off/on) to
effectuate the change.
Change port number for TCP/IP
(Service Mode)
Press
Enter
to change the port number.
This port is used for SioxNet TCP/IP
communications used by SioxTools and
Profcon AB
Page 11
www.smokecontrol.net
CHANGE PIN CODE
NEW PIN: 5555
C=ABORT
CHANGE IP-ADDRESS
C=ABORT,ENTER=OK
192.168.000.234
CHANGE TCP/IP PORT
C=ABORT,ENTER=OK
PORT:01024
CHANGE IP-GATEWAY
C=ABORT,ENTER=OK
192.168.000.001
SET SUBNET MASK
C=ABORT,ENTER=OK
255.255.255.000
