14
ASSEMBLY INSTRUCTIONS….cont
Lastly fit the fence as shown in the pic-
ture.
Surface sanding on sanding
belt
Note:
This belt disc sander is designed only for sanding operations involv-
ing wood or wood derived products. It is not suitable for use with any type
of metal - your warranty will be void if the sander is used for this purpose.
OPERATING INSTRUCTIONS
Note when sanding on the
belt sander be sure not to ap-
ply too much pressure, Always
remember this is not suitable
for any type of metal as this will
void your warranty and dam-
age the machine.
11
ASSEMBLY INSTRUCTIONS….cont
Leg Stand Assembly
Take upright leg (A) x2 and bolt to lower sup-
port (length) (B) x1 using the bolts supplied on
both sides until you have a `H` frame as show
in below diagram, Now repeat above steps
until there are two `H` frames.
A
B
Now attach both lower supports (width)
(C) to one `H` frame, and proceed to
attach the 2nd `H` frame to opposite
end of the lower supports (width) (C) , As
shown in picture right.
C
Attach the upper supports (length &
width) (D & E) to the frame and complete
the leg-set by pressing 4 rubber feet to
the bottom of each leg.
D
E
Note:
Do not fully tighten the bolts at
this point as some adjustment may be
necessary.
