20
PARTS LIST Continued...
No.
Description
SIP Part No.
38
Screw M6 x 16
WD02-00034
39
Main base
WD02-00042
40
Motor cover
WD02-00043
41
Sanding belt safety guard
WD02-00044
42
Self tapping screw 4 x 12
WD02-00045
43
Screw M6 x 150
WD02-00046
44
Rubber sleeve
WD02-00047
45
Support stem
WD02-00048
46
Lock base sander belt
WD02-00049
47
Motor
WD02-00050
48
Bolt M8 x 16
WD02-00051
49
Lock washer
WD02-00052
50
Motor drive pulley
WD02-00053
51
Washer (big)
WD02-00054
52
Bolt (left) M6 x 12
WD02-00055
53
Belt cover
WD02-00056
54
Timing belt
WD02-00057
55
Drive pulley
WD02-00058
56
Hex socket cap screw M5 x 40
WD02-00059
57
Bearing support
WD02-00060
58
Sander lock plate
WD02-00061
59
Hex socket cap screw M8 x 25
WD02-00062
60
Retaining ring 15 mm
WD02-00063
61
Ball bearing
WD02-00064
62
Drive shaft
WD02-00065
63
Screw M5 x 15
WD02-00066
64
Rubber washer
WD02-00067
65
Tension lever
WD02-00068
66
Lever spacer
WD02-00069
67
Washer
WD02-00070
68
Index spring
WD02-00071
69
Rubber bushing
WD02-00072
70
Retaining ring 12 mm
WD02-00073
71
Ball bearing 6201
WD02-00074
72
Idler drum
WD02-00075
73
Idler shaft
WD02-00076
74
Drum guide
WD02-00077
75
Index spring
WD02-00078
76
Mains Lead
WD02-00079
77
Table angle Guide
WD02-00080
78
Table frame bracket
WD02-00081
5
SAFETY INSTRUCTIONS….cont
Ensure that the belt disc sander is correctly turned off when not in use and store in a
safe, dry area, out of reach of children.
Do not unplug the belt disc sander to switch it off - always use the on/off switch.
Keep all combustible materials away from this belt disc sander.
ALWAYS locate belt disc sander on a stable and level surface.
ALWAYS keep children and animals away from belt disc sander.
Never stand on the belt disc sander.
DO NOT dismantle or tamper with the belt disc sander, as this may be dangerous
and will invalidate the warranty.
If a problem with the belt disc sander is experienced, or if the mains lead or plug be-
come damaged, contact your distributor for repair.
The Electricity at Work Act 1989 requires that all portable electrical appliances, if used
on business premises, are tested by a qualified electrician, using a Portable Appliance
Tester (PAT), at least once a year.
WARNING:
Risk of Electric Shock!
Use only the electrical power (voltage and frequency) specified on the model plate
of the belt disc sander. If in doubt contact the manufacturer.
Use only a three-prong, grounded outlet and where required.
ALWAYS unplug the belt disc sander when not in use.
Safety Symbols Used Throughout This Manual
Danger / Caution: Indicates risk of personal injury and/or the possibility of
damage.
Warning: Risk of electrical injury or damage!
Note:
Supplementary information.
