© 2003 - 2005 Sipura Technology, Inc
Proprietary (See Copyright Notice on Page 2)
108
Current Min
On-Hook Speed
Choose from {Less than 0.5ms, 3ms (ETSI), 26ms
(Australia)}
Less than
0.5ms
Choice
Current Limiting
Enable
no
Bool
Ring Frequency
Min
Minimum ring frequency to detect
10
5-100
Ring Frequency
Max
Maximum ring frequency to detect
100
5-100
Ring Validation
Time
Choose from {100, 150, 200, 256, 384, 512, 640,
1024} (ms)
256ms Choice
Ring Indication
Delay
Choose from {0, 512, 768, 1024, 1280, 1536, 1792}
(ms)
512ms Choice
Ring Timeout
Choose from {0, 128, 256, 384, 512, 640, 768, 896,
1024, 1152, 1280, 1408, 1536, 1664, 1792, 1920}
(ms)
640ms Choice
Ring Threshold
Choose from {13.5–16.5, 19.35–2.65, 40.5–49.5}
(Vrms)
13.5–16.5
Vrms
Choice
Ringer Impedance
Choose from {High, Synthesized(Poland, S.Africa,
Slovenia)}
High Choice
4.13.8. Line 1 and PSTN Line – Audio Configuration
Parameter
Description
Default
Range
Symmetric RTP
If enabled, the SPA will stream RTP packets to the
source IP address and port of the last received RTP
packet. If not enabled or before the 1
st
RTP packet
arrives, SPA will stream RTP packets according to
the information extracted from the SDP sent by the
peer.
yes Bool
4.13.9. Line 1 – Gateway Accounts
Parameter
Description
Default
Range
Gateway 1
The first of 4 gateways that can be specified to be used
in the <Dial Plan> to facilitate call routing specification
(that overrides the given proxy information). This
gateway is represented by “gw1” in the <Dial Plan>. For
example, the rule “1408xxxxxxx<:@gw1> can be added
to the dial plan such that when the user dials
1408+7digits, the call will be routed to Gateway 1.
Without the <:@gw1> syntax, all calls are routed to the
given proxy by default (except IP dialing)
[blank] FQDN
Gateway 2–4
Same as above with ‘1’ replaced by ‘1’ – ‘4’
[blank]
FQDN
GW1 NAT Mapping
Enable
If enabled, the SPA will use NAT mapping when
contacting Gateway 1
no Bool
GW1–4 NAT
Mapping Enable
Same as above with ‘1’ replaced by ‘1’ – ‘4’
no
Bool
GW1 Auth ID
This is the authentication user-id to be used by the SPA
to authenticate itself to Gateway 1
[blank] Str31
