© 2003 - 2005 Sipura Technology, Inc
Proprietary (See Copyright Notice on Page 2)
109
GW1–4 Auth ID
Same as above with ‘1’ replaced by ‘1’ – ‘4’
[blank]
Str31
GW1 Password
This is the password to be used by the SPA to
authenticate itself to Gateway 1
[blank] Str31
GW1–4 Password
Same as above with ‘1’ replaced by ‘1’ – ‘4’
[blank]
Str31
4.13.10. Line 1 – VoIP Fallback To PSTN
Parameter
Description
Default
Range
Auto PSTN Fallbak If enabled, the SPA will automatically route all calls to
the PSTN gateway when the Line 1 proxy is down
(registration failure or network link down).
yes Bool
4.13.11. Line 1 – Dial Plan
Parameter
Description
Default
Range
Dial Plan
The dial plan syntax is expanded in the SPA-3000 to
allow the specification of 3 parameters to be used with a
certain gateway:
1. uid – the authentication user-id,
2. pwd – the authentication password, and
3. nat – if this parameter is present, use NAT
mapping
Each parameter is separated by a semi-colon (;).
Furthermore, it recognizes “gw0”, “gw1”, …, “gw4” as
the locally configured gateways, where “gw0” represents
the local PSTN gateway in the same SPA-3000 unit.
Example 1:
“*1xxxxxxxxxx<:@fwdnat.pulver.com:5082;uid=jsmith;p
wd=xyz”
Example 2:
“*1xxxxxxxxxx<:@fwd.pulver.com;nat;uid=jsmith;pwd=x
yz”
Example 3:
“[39]11<:@gw0>
[blank] Str2048
4.13.12. User1 – Call Forward Settings
Parameter
Description
Default
Range
Cfwd All Dest
In addition to normal call forward destination as used
in the SPA-1000 and SPA-2000, one can specify in
the SPA-3000:
1. gw0 – forward the caller to use the PSTN
gateway
2. <pstn-number>@gw0 – forward to caller to
the PSTN number (dialed automatically by
[blank] Str39
