© 2003 - 2005 Sipura Technology, Inc
Proprietary (See Copyright Notice on Page 2)
80
Ring3 Name
Name in an INVITE’s Alert-Info Header to pick
distinctive ring/CWT 3 for the inbound call
Str31 Bellcore-r3
Ring4 Name
Name in an INVITE’s Alert-Info Header to pick
distinctive ring/CWT 4 for the inbound call
Str31 Bellcore-r4
Ring5 Name
Name in an INVITE’s Alert-Info Header to pick
distinctive ring/CWT 5 for the inbound call
Str31 Bellcore-r5
Ring6 Name
Name in an INVITE’s Alert-Info Header to pick
distinctive ring/CWT 6 for the inbound call
Str31 Bellcore-r6
Ring7 Name
Name in an INVITE’s Alert-Info Header to pick
distinctive ring/CWT 7 for the inbound call
Str31 Bellcore-r7
Ring8 Name
Name in an INVITE’s Alert-Info Header to pick
distinctive ring/CWT 8 for the inbound call
Str31 Bellcore-r8
Ring Waveform
Waveform for the ringing signal
{Sinusoid,
Trapezoid}
Sinusoid
Ring Frequency
Frequency of the ringing signal. Valid values
are 10 – 100 (Hz)
Uns8 25
Ring Voltage
Ringing voltage. 60-90 (V)
Uns8
70
CWT Frequency
Frequency script of the call waiting tone. All
distinctive CWT is based on this tone.
FreqScript 440@-10
Notes:
3.5.9.3. Control Timer Values (sec)
Parameter Name
Description
Type
Default
Hook Flash Timer Min
Minimum on-hook time before off-hook to
qualify as hook-flash. Less than this the on-
hook event is ignored. Range: 0.1 – 0.4 sec
Time3 0.1
Hook Flash Timer Max
Maximum on-hook time before off-hook to
qualify as hook-flash. More than this the on-
hook event is treated as on-hook (no hook-
flash event). Range: 0.4 – 1.6 sec
Time3 0.9
Callee On Hook Delay
The phone must be on-hook for at this time in
sec before the SPA will tear down the current
inbound call. It does not apply to outbound
calls. Range: 0 – 255 sec
Time0 0
Reorder Delay
Delay after far end hangs up before reorder
tone is played. 0 = plays immediately, inf =
never plays. Range: 0 – 255 sec
Time0 5
Call Back Expires
Expiration time in sec of a call back activation.
Ragne: 0 – 65535 sec
Time0 1800
Call Back Retry Intvl
Call back retry interval in sec. Range: 0 – 255
sec
Time0 30
Call Back Delay
Delay after receiving the first SIP 18x response
before declaring the remote end is ringing. If a
busy response is received during this time, the
SPA still considers the call as failed and keeps
on retrying.
Time3 0.5
VMWI Refresh Intvl
Interval between VMWI refresh to the CPE
Time3
0.5
Interdigit Long Timer
2
Long timeout between entering digits when
dialing. Range: 0 – 64 sec
Time0 10
Interdigit Short Timer
2
Short timeout between entering digits when
dialing. Range: 0 – 64 sec
Time0 3
