© 2003 - 2005 Sipura Technology, Inc
Proprietary (See Copyright Notice on Page 2)
91
Call Back Active
Indicate whether a call back request is in progress: Yes or No
Last Called Number
The last number called
Last Caller Number
The number of the last caller
Mapped SIP Port
NAT Mapped SIP Port
Call 1/2 Status
State
State of the call: Idle, Dialing, Calling, Proceeding, Ringing, Answering,
Connected, Hold, Holding, Resuming, or Reorder
Tone
Tone playing for this call: Dial, 2
nd
Dial, Outside Dial, Ring Back, Ring,
Busy, Reorder, SIT1– 4, Call Waiting, Call Forward, Conference,
Prompt, Confirmation, or Message-Waiting
Encoder
Encoder in use: G711u, G711a, G726-16/24/32/40, G729a, or G729ab
Decoder
Decoder in use: G711u, G711a, G726-16/24/32/40, G729a, or G729ab
FAX
Indicate whether FAX pass-through mode has been initiated: Yes or No
Type
Indicate the call type: Inbound or Outbound
Remote Hold
Indicate whether the remote end has placed the call on hold: Yes or No
Call Back
Indicate whether the call is triggered by a call back request: Yes or No
Peer Name
Name of the peer
Peer Phone
Phone number of the peer
Duration
Duration of the call in hr/min/sec format
Packets Sent
Number of RTP packets sent
Packets Recv
Number of RTP packets received
Bytes Sent
Number of RTP bytes sent
Bytes Recv
Number of RTP bytes received
Decode Latency
Decoder latency in milliseconds
Jitter
Receiver jitter in milliseconds
Round Trip Delay
Network round trip delay (ms); available if the peer supports RTCP
Packets Lost
Total number of packets lost
Packet Error
Number of RTP packets received that are invalid
Mapped RTP Port
NAT mapped RTP port
