Siqura 9961A-C, Installation And Operation Manual

13 

Operation of the 9961A-C 

Operation is straightforward. Connect per the Configuration and Connection Guide on page 4. There are no 

adjustments. Under normal operation, if operating in DUPLEX mode, only the green “PWR,” “SYNC,” and 

“LOOP” indicators on each unit will be illuminated. If operating in SIMPLEX mode, only the “PWR” indicator on 

the transmit end and the “SYNC” and “PWR” indicators on the receive end will be illuminated. Good data 

and/or audio transmission will be apparent.  

Operation of the 9961A-C with Network Management System 
Software 

Operation of the 9961A-C with the Network Management System consists of the following parameters:  

1.

Card Location  

2.

Card Size (Number of Slots)  

3.

Card Name (Model Number)  

4.

Serial Number  

5.

Revision Number  

6.

Chronometer Value (Cumulative Hours of Operation)  

7.

Reset Cycles (Cumulative Number of Power Cycles)  

8.

Firmware Revision  

9.

Local Demux in Sync (in Transceiver and Receiver Operation Only)  

10.

Remote Demux in Sync (in Transceiver Operation Only)