7
EMC
The equipment has been tested and found to meet the CE-
regulations relating to EMC, and complies with the limits for a
Class B device, pursuant to Part 15 of the FCC rules.
These limits
are designed to provide reasonable protection against interference to
radio communications in any installation. The equipment generates,
uses and can radiate radio frequency energy; improper use or special
circumstances may cause interference to other equipment or a
performance decrease due to interference radiated by other equipment.
In such cases, the user will have to take appropriate measures to
reduce such interactions between this and other equipment.
Any interruption of the shielding inside or outside the equipment could
cause the equipment to be more prone to fail EMC requirements.
Non-video signal lines must use appropriate shielded CAT5 cabling
(S-FTP), or at least an equivalent.
If system components, such as cabling (e.g. coaxial cable,
data/audio/cc wiring) and/or the units, are used outdoors, ensure that
all
electrically connected components are carefully earthed and
protected against surges (high voltage transients caused by switching
or lightning).
ESD
Electrostatic discharge (ESD) can damage or destroy electronic
components. Proper precautions should be taken against ESD
when opening the equipment.
*)
SELV: conforming to IEC 60950-1, <60V
DC
output, output voltage
galvanically isolated from mains. All power supplies or power supply
cabinets available from Siqura comply with these SELV requirements.
9. Product disposal
Recycling
The unit contains valuable materials which qualify for
recycling. In the interest of protecting the natural
environment, properly recycling the unit at the end of
its service life is imperative.
