Tab 15
-
XR1-025-EC…
3. Unit Installation
1. General information, recommendations, and safety when installing the Xroom units
1.
Electrical safety before installation of the unit
-
Before starting any installation work, make sure that the wiring box or mains socket that you want to
use to connect the unit is equipped with a protective (green-yellow) wire or contact (pin).
-
If you use a wiring box to electrically connect the unit, you must turn off the power and secure the
power supply against accidental turn on.
-
Check that the electrical connection point (wiring box, outlet) meets the unit's power supply
requirements (voltage, current, etc.) specified on the unit's serial plate. The electrical quantities
necessary for the unit's operation can be found in Section 3.3.3. Display of electrical parameters
2.
Unpacking
1.
Unpacking the Xroom Unit – Box 1
-
Always unpack the unit in a sufficiently large area to allow for removing the unit from the packaging.
-
Never unpack the entire unit from the packaging, the unpacking of the unit must be gradual, as specified
in this manual according to the installation work in progress (protection of the unit from damage and dust
generated during installation)
-
Proceed as follows:
18
Version 1 – GBR(23/06/2021)
D-502-0152
