Registered in England No. 08405712
VAT Registration No. GB163 04 0349
Siretta Ltd
Basingstoke Road
Spencers Wood
Reading
Berkshire RG7 1PW
sales
email
web
+44(0)118 976 9000
sales@siretta.com
www.siretta.com
37
QUARTZ-ONYX
Hardware Manual
The QUARTZ-ONYX will accept any data enabled SIM card. These may be Pay
As You Go (PAYG) or Contract, fixed IP address or normal consumer SIM cards.
However, it is recommended that a contract SIM card be used. These are normally
shipped ready for use. PAYG SIM cards often need to be activated first in a normal
phone before being used in a router.
The SIM card holder is designed to accept either one or two mini-SIM (2FF)
(measuring 25 mm x 15 mm). The SIM card voltages supported are 1.8 V and 3.3 V,
meaning that the interface will be compatible with any SIM card manufactured after
1998.
Use a 00 Philips screwdriver to remove the screw retaining the plate covering the
dual SIM card socket to be able to insert one or two SIM cards. Only one SIM card
is necessary for operation. A second SIM card may be used for failover or backup
operation. If using one SIM card, either SIM socket may be used.
Note that alignment mark on the SIM card should match the marking on the
QUARTZ-ONYX. The SIM card should be inserted with the electrical contacts face
down. Note which SIM card is inserted into the lower slot (‘SIM 1’) and which inserted
into the upper slot (‘SIM 2’). This information will be required when setting up the
QUARTZ-ONYX.
Figure 19.
Remove SIM cover plate
Figure 21.
With one SIM fitted
Figure 20.
Dual SIM card holder
SIM Socket