Customer Service 1-888-707-1880
or email customerservice@dyaco.ca Dyaco Canada Inc. ©2014
20
Trouble shooting
Problem Cause
Correction
Monitor does not
display
Monitor wire not connected
Connect the monitor wire
Batteries are not working
Replace batteries
Monitor not working properly
Replace monitor
No speed or distance
displays on the
monitor
Sensor wire not connected
Securely plug the sensor wire into the
extension wire and at the back of the
monitor
Sensor wire not working
properly
Replace sensor wire
Monitor not working properly
Replace monitor
No tension
Tension control
w/cable not properly connected
Securely connect the tension control
with the extension tension cable
Flywheel not working properly
Replace flywheel
Tension control w/cable
defective
Replace the tension control w/cable
Heart rate not
displaying
Pulse wire not connected
Securely plug wires into the back of
the monitor
Hand pulse defective
Replace hand pulse grip
Monitor not working properly
Replace monitor
Grinding
Crank bearing defective
Replace crank bearings
Flywheel defective
Replace flywheel
Squealing
V-belt slipping
Adjust v-belt
Maintenance
The safety of this produce can be maintained only if regular periodic checks are made. Most checks can
be performed once a week. However some checks should be made before each workout, and are
indicated as such below.
Checks
Check that seat nuts are secure, check before each workout.
Check that pedals are tight, pedals can work loose over time.
Check that stabilizer bolts are tight, check before each workout this.
Check that handlebar is secure, if not, tighten, check before each workout this.
Should a part become defective, replace it immediately. Do not allow use of the equipment until it
has been repaired.
Cleaning
Almost all surfaces are washable. A damp cloth is sufficient to clean most surfaces of this unit. Be careful
not to drip water on the monitor. A mild liquid soap may be added if needed.
