7 / 8
2. Introduction
Thank you for buying the CXT-11.
It is a powerful device.
For a successful installation and operation, please read this manual carefully.
3. Start up
Your Cable Tester is delivered ready for use.
To insert or change the Batteries you have to disassemble the 2 screws on the back.
Take Out the old Batteries and insert new ones.
After that, make sure to re-assemble the plate firmly.
4. Control
Insert one end of the cable to the connector of the left half of the tester.
Then insert the other end on the right side of your CXT-11.
Press the Power Button to start the test.
You can see if the cable is working by watching the LED’s.
Summary of Contents for CXT-11
Page 1: ...Manual Cable tester CXT 11...
