background image

A.  Mount the Magnetic Mount Antenna outside your vehicle, on a clean and dry 

horizontal surface that will always face the sky.

B.  The best location is on the roof above the front windshield, centered between 

the left and right sides.

C.  Install the Cable Routing Adapter to direct the antenna cable downward, if mounting on an 

edge. 

TIP:

 Use the Alcohol Prep Pad to clean 

the surface.

CAUTION:

 Do not attempt to install, activate, or adjust any of the setting options described in this 

Quick Start Guide unless your vehicle is parked in a safe location.

What’s in the Box? 

Snap Radio

Magnetic Mount 

Antenna

Antenna Alcohol
Preparation Pad

Aux In Cable

1

2

3

4

5

Cable 

Routing Adapter

Alcohol

Prep Pad

Mount the Magnetic Mount Antenna 

Route the Antenna Cable 

Find a Location for Snap and Mount It 

Sedans and Coupes

Pickups and SUVs

Convertibles*

*  If the antenna can not 

be placed above the 

windshield, place it on 

vehicle hood.

A.  Tuck the antenna cable under the windshield rubber 

molding and run it to the nearest corner. 

B.  Route the cable out of the molding and into the rubber 

weather stripping around the door opening. 

C.  Lift the weather stripping. Tuck and run the cable 

inside it to the bottom of the door opening. Replace the 
weather stripping.

D.  Pull the cable out and route it toward the power adapter 

or cigarette lighter socket location. 

E.  Plug the Magnetic Mount Antenna connector into the 

ANTENNA connector on the Base of Snap.

TIP:

 Include enough slack in your routing to 

accommodate open doors or the hood lid. Coil 
any excess cable in a hidden location and 
keep it away from any vehicle pedals or 
controls.

Place Antenna

Closer to A-Pillar

if Cable Doesn’t Reach 

Center of Roof

Power Adapter or

Cigarette Lighter

Socket Location

ANTENNA

AUDIO

FM

Antenna

Connector

Base

Antenna

Plug

Flexible

Stalk

Initiate the Courtesy Period

A.  Power on your Snap by pressing the Power button. Ensure the 

vehicle is outside and the antenna has a clear view of the sky.

B.  When prompted, press the number button 1, then 2, then 3. The 

Courtesy Period Begun message will verify that the Courtesy Period 
has begun.

C.  You will be notified about the length of the Courtesy Period and 

prompted to set up the audio connection. Snap will then tune to 
channel 1.

TIP: 

At this point, you should have access to all the channels in a few 

minutes. However, leave Snap tuned to channel 1 until you have set up the 
audio connection.

NOTE: 

If Acquiring Signal or Chk Antenna Connection is displayed, verify 

that you have mounted and connected the antenna. Refer to “Mount the 
Magnetic Mount Antenna” on page 14, or to “Troubleshooting” on page 42 of 
the User Guide for additional help.

MENU FM

Connect the Audio 

Decide on one of the following in-box audio connection options. Refer to “Connect the Audio” on page 
23 of the User Guide for details including other connection options.

Option 1: Best: Use the provided Aux In Cable, if your vehicle’s stereo system has an auxiliary input jack.

A.  Plug one end of the cable into the AUDIO connector on Snap and the other end into the auxiliary 

input jack on the vehicle’s stereo system. 

B.  Turn on your vehicle’s stereo system and set it to play from the auxiliary input source.

C.  You should now hear the XM channel 1. The installation is complete.

TIP!

 Refer to your vehicle’s owner’s manual to find the location of the auxiliary input jack, or consult the 

vehicle dealer.

AUDIO

FM

Audio

Connector

Aux In Cable

Aux In

continued on other side...

A.  Mount Snap by plugging the Base into the power adapter or cigarette lighter socket.

B.  Grasp the rear of Snap’s Base and gently push in, while at the same time rotating the Base 

slightly to the right and then to the left. Do not push it in by holding the Radio Control Unit or 
Flexible Stalk. 

TIP:

 Choose a socket that doesn’t interfere with the driver’s vision or access to driving controls, won’t 

interfere with the deployment of airbags or other safety equipment, and makes Snap easily accessible for 
operation.

Power Adapter or

Cigarette Lighter 

Socket

1

2

3

4

5

Rock

Underground

25   

Press 1,2,3

To Begin

Courtesy

Period Begun

1

2

3

4

5

Meijer.com

Reviews: