16
Vehicle Installation
3.
Attach the Vent Mount to the
Power
Connect Vehicle Dock using the 4
provided screws .
4.
Before you attach the Vent Mount to the
vent, skip ahead and finish the remainder
of the vehicle installation so that the
cables are attached to the dock .
Note!
For greater clarity, the next
illustration does not show the dock
attached to the Vent Mount, however, the
dock should be attached before continuing .
5.
Once the cables have been attached to the dock, push the Vent Mount
onto the vehicle vent as shown (1) until it hooks on the rear of the vent
louver (2) .
6.
Rest the foot against the bottom of the vent (2), and adjust the tilt of the
Vent Mount by repositioning the foot to a different adjustment hole (3) .
TIP!
To remove the Vent Mount, push the mount into the vent . Then lift up
until disengaged from the rear of the vent louver, and remove the Vent
Mount .
PUSH
Dash
Vent
Louver
Vent
Vent
Dash
Dash
HOOKED
TILT
ADJUSTMENT
HOLES
FOOT
1
2
3
AUDIO
ANT
PWR
FM