33
Pickup Truck:
1.
Use a blunt plastic putty knife or similar blunt tool to lift the rubber
molding around the windshield and tuck the antenna cable underneath
it .
2.
Continue tucking the cable underneath the windshield molding around
the windshield to the lowest corner .
3.
At the lowest corner of the windshield, route the cable out of the
windshield molding and into the rubber weather stripping around the
door opening . Lift the weather stripping from the opening and tuck the
cable inside it, then replace the weather stripping . Run the cable inside
of the weather stripping to the bottom of the door opening .
4.
Pull the cable out of the weather stripping at the bottom of the door
opening and route it under the carpet toward the dashboard . Coil any
excess cable in a hidden location, such as under the carpet, keeping it
away from any vehicle pedals or controls . Secure the excess cable with
wire ties .
5.
Bring the end of the cable out at the
Power
Connect Vehicle Dock location .
Leave yourself enough cable so you can
easily connect it to the antenna connector
of the dock .
6.
Continue with “Step 5: Connect
the Magnetic Mount Antenna and
Power
Connect Power Adapter” on page
34 .
Vehicle Installation
