35
connector of the dock.
6. Continue with “Step 5: Connect the Magnetic Mount Antenna
and
Power
Connect Power Adapter” on page 37 .
•
Pickup Truck:
1. Use a blunt plastic putty knife or similar blunt tool to lift the
rubber molding around the windshield and tuck the antenna
cable underneath it.
2. Continue tucking the cable underneath the windshield molding
around the windshield to the lowest corner.
3. At the lowest corner of the windshield, route the cable out of
the windshield molding and into the rubber weather stripping
around the door opening. Lift the weather stripping from the
opening and tuck the cable inside it, then replace the weather
stripping. Run the cable inside
of the weather stripping to the
bottom of the door opening.
4. Pull the cable out of the
weather stripping at the bottom
of the door opening and route
it under the carpet toward the
dashboard. Coil any excess
cable in a hidden location, such
as under the carpet, keeping it
away from any vehicle pedals
or controls. Secure the excess
cable with wire ties.
Summary of Contents for Onyx
