11
Wi-Fi Sound Station User Guide
Manually Connecting to a Wireless Network
To manually connect to a wireless network, you’ll need to know the SSID (wireless network name), password,
and type of encryption, and also may need additional information about your wireless network if it is not
DHCP enabled:
SSID (wireless network name)
Password
Encryption (None, WEP, WPA-PSK)
If not DHCP:
IP Address (for the Wi-Fi Sound Station)
Mask (Network Mask IP Address)
Gateway (Gateway IP Address)
DNS (Primary Name Server IP Address)
1.
Plug the AC Power Adapter into an AC outlet, and plug the power plug into the connector on the rear
of the Wi-Fi Sound Station . Press the
Power
button if the Wi-Fi Sound Station does not automatically
turn on .
2.
If the Sound System has not previously connected to a wireless network, the Wi-Fi Sound Station will
display the Network Wizard screen, with Wireless highlighted . Press the
Tune Knob
.
Otherwise, press the
Home
button and press the
Settings
button . Turn the
Tune knob
to highlight
Network Wizard and press
Tune knob
to select . Wireless will be highlighted; press
Tune knob
to select .
3.
At the Wireless screen, Scan will be highlighted . Turn the
Tune knob
to highlight Manual
and then press
the
Tune knob
.
4.
SSID (wireless network name) will be highlighted . Press the
Tune Knob
.
Enter the SSID by turning the
Tune knob
to highlight each character of the
SSID and press the
Tune knob
to select the character . If you make an error,
press the
BACK
button to erase the entered character . When you have
completed entering the SSID, press the
Submit
button .
5.
Turn the
Tune knob
and highlight Password . To enter the password, turn
the
Tune knob
to highlight each character of the password and press the
Tune knob
to select the character . If you make an error, press the
BACK
button to erase the entered character . When you have completed entering
the password, press the
Submit
button .
6.
Turn the
Tune knob
and highlight Encryption . Turn the
Tune Knob
to highlight the type of encryption
and press the
Tune Knob
to select .
7.
If DHCP is enabled on your wireless network, turn the
Tune Knob
and highlight DHCP Connect and press
the
Tune Knob
. Skip ahead to step 14 .
If DHCP is not enabled on the wireless network, turn the
Tune Knob
and highlight Static IP and press
the
Tune Knob
.
8.
IP will be highlighted . Press the
Tune knob
to select . Enter the IP Address . The IP address must be
entered in the xxx .xxx .xxx .xxx format . When you have completed entering the IP address, press the
Submit
button .
9.
Enter the Network Mask in the same way as you entered the IP Address .
10.
Enter the Gateway IP Address in the same way .
11.
Enter the DNS IP Address in the same way .
Installation
