Sirman TC 22, Instruction Manual For Use And Maintenance

21 

English 

-  load the p

oduct to be ground into the meat grinder’s hopper

-  start the meat grin

er by pressing the start button

- the ground meat that comes out of the meat grinder’s mouth fills the hamburger die

-

-

visually inspect the process and remove the hamburger once it has been formed, by

turning the 

hamburger forming accessory slider anti-clockwise, holding it from the knob

only in this way will 

the machine stop working and pushing the ground meat

outwards

-  after removi

g the hamburger from inside the die, put the slider back into place

by 

turning it clockwise, holding it from the knob

-  this

will cause the hamburger production cycle to resume

7 - Maintenance

7.1 - Requirements

WARNING! 

All the maintenance and cleaning must be performed with the machine at a 

standstill, disconnected from the power mains. The area where maintenance operations are 
performed must always be kept clean and dry.  
Do not allow unauthorized personnel to service machinery. 
Any replacement of parts, including replacement of the utensils must be made with original 
parts from authorised shops or directly from the manufacturer. 

7.1 - Lubrication

The machine does not require lubrication. 

-

after removing the hamburger from inside the die, put the slider back into place by 

turning it clockwise, holding it from the knob

-

this will cause the hamburger production cycle to resume

The sliders come with different dies for the

hamburgers:

- S1 Chicken leg - approx. 105 g
- S2 Oval - approx. 130 g
- S3 Meat balls - approx. 20 (x4) g
- S4 Square - 100 x 100 mm - approx. 150 g
- S5 rectangular - 100 x 125 mm - approx. 190 g
- S6 Round - ø 110 mm - approx. 155 g
- S7 Round - ø 100 mm - approx. 140 g
- S8 Adjustable from round to oval - 100 g – 200 g

6.6.3 Detaching the hamburger forming accessory from 
the meat grinder

- with the meat grinder switched off, raise the fastening lever and unlock the

hamburger forming accessory

- hold the hamburger forming accessory with both hands and push it towards you

- remove it from the ring nut and from the two pins at the base of the casing