1
1.
Functional overview
The remote control SI1602 is a radio transmitter, which can be used to manually remotely
control drives of the unidirectional LE-series from SIRO.
With SI1602 you can control up to 15 drives individually. Use the P1 buttons to define the
channel of the respective drive before teaching-in individual drives.
Channel 0 is reserved for the control of all connected channels, allowing you to control all drives
simultaneously.
2. Installation
The remote controller SI1602 requires a battery cell type CR2450 – 3V as power
source. To ensure that the device can execute all commands, it is recommended to
replace empty batteries in time
.
1.
Open the battery compartment of the remote controller on the back by sliding the cover
down.
2.
Insert the battery into the battery compartment with the plus pole facing upwards.
3.
Close the battery compartment. The display flashes.
Please refer to the operation instructions of the LE-series drive you have received for the
procedure of teaching-in and end position setting
.
