62 14 972 D 3507
D 3507
.
031.01.07
.
02 11.2010
29
Sirona Dental Systems GmbH
Installation
Installation Instructions HELIODENT
PLUS
Installing the manual release holder
båÖäáëÜ
5.5.3
Installation on the protective cover of the remote control
empty
Explanation
The protective cover must be modified to install the holder.
empty
Scope
For installation options: 2, 4, 6 and 6.1
empty
Modification
1. Remove the remote control release button (S9) from the protective
cover.
2. Turn the protective cover over on its back.
ª
You will see a hexagonal recess (M).
3. Drill a 4.3 mm (3/16") hole at the center of the recess (M).
4. Pull off the protective foil of the two-sided adhesive tape at the holder
(H).
5. Adhere the holder (H) to the front of the cover to match the drilled hole
(watch for top/bottom alignment).
6. Place an M4 hex nut into the recess (M).
7. Fasten the holder (H) with an M4x16 screw from the front.
S9
M
H
IMPORTANT
Make sure that the holder is mounted in the correct position.
