62 38 328 D3439
D3439
.
092.05.03
.
02 04.2010
9
Sirona Dental Systems GmbH
Installing the manual block clamp
Installation Instructions for Manual Block Clamp CEREC MC XL, inLab MC XL
Installing the block clamp
bå
Öä
áë
Ü
4.4
Installing the block clamp
1. Place the installation tool with the block clamp in the unit.
2. Screw the block clamp onto the block shaft. To do this, hold the shaft key
(A) in the 9 o'clock position with one hand while turning the installation
tool with the other hand (B).
3. Tighten the block clamp securely.
4. Unscrew and remove the locking screw.
5. Pull the installation tool off of the block clamp.
empty
Adjusting the block change position
CEREC
1. Connect the power plug and switch the milling unit on at the main switch
(I).
2. The block axle automatically travels to the block change position
3. Switch the milling unit off at the main switch (0) and disconnect the power
plug.
NOTICE
Place the installation tool properly
Observe the following instructions. The shaft must not be twisted in the pro
-
cess.
The block clamp must rest on the thread of the block shaft.
The handle of the shaft key (A) is set to the 9 o'clock position.
The hex insert bit at the lower end of the shaft wrench is inserted in the
hex socket of the block shaft.
Summary of Contents for inLab MC XL
