Sirona Dental Systems GmbH
15 Key combinations
Operating Instructions PerioScan
61 29 626 D 3496
D 3496.201.02.05.02
43
båÖäáëÜ
15
Key combinations
Signal mode:
The signal mode can be activated by simultaneously
pressing the "
Small rinsing media tank
" and "
PERIO 1
"
keys. As soon as the signal mode is activated, the tooth
displayed on the screen starts flashing. Here, it is possi-
ble to adjust the volume of the signal with the
50 %
and
100 %
keys. Furthermore, the signal tone can now be
assigned to the detection of calculus with the "
PERIO 1
"
key or to noncontact of the tip with the root surface
with
the "
PERIO 2
" key. The user can see which function he
has activated based on the readings that appear on the
display following his selection (doctoral cap = signal set
to noncontact of tip with root surface).
The signal tone can be deactivated (detection of calcu-
lus or noncontact of tip on root surface)
by pressing the
activated key once again. You can quit the signal mode
by simultaneously pressing the "
Small rinsing media
tank
" and "
PERIO 1
" keys once again.
Deactivating the detection function:
The detection function must be deactivated until the
SIROPERIO 4
or
SIROPERIO PE 8
tip is attached. This
is done
by pressing key
. Once the
SIROPERIO 4
or
SIROPERIO PE 8
tip has been attached,
the detection
function can be activated by simply pressing key
.
Patient communication system:
To change to the patient communication mode, you
must simultaneously press the "
Large rinsing media
tank
" and
PERIO 2
" keys. 3 teaching images are avail-
able here to support your communication with your
patient. This will simplify explaining the treatment proce-
dure and the reason for the treatment to your patient.
You can select the individual images using the three
"
PERIO
" keys.
To quit the patient communication mode, simultaneously
press the "
Large rinsing media tank
" and "
PERIO 2
"
keys once again.
Reset:
To reset the PerioScan to its factory settings, press and
hold key
while simultaneously switching the unit off
and on again.
Deactivating the boost function:
The boost function can be switched off by simultane-
ously pressing
and
. The text "
Boost
" then dis-
appears at the bottom center of the display. To reacti-
vate the boost function, press
keys
and
simul-
taneously.
Continuous flushing (60 s):
Continuous flushing can be activated for 60 seconds by
pressing key
. This function can be terminated by
pressing key
once again or by pressing the foot
switch.
1
1
1
1
2
1
2
2
2
