61 93 556 D3509
D3509
.
201.01.02
.
02
19.09.2008
183
Sirona Dental Systems GmbH
11 Overview of all function keys
Operating Instructions TENEO
Treatment program
Increases the intensity setting of the SIROSONIC TL scaler in steps of 20%
referenced to the final value during treatment. With an intensity of 80%, only
the maximum value of 100% can be selected.
Endodontics function
Activation of the endodontics function for the SIROSONIC TL scaler (power
limitation)
Chip blower
Used to dry treatment areas or blow off drilling chips by emitting air blasts
from the treatment instrument
This key is displayed only when cursor control is activated
Activate preselected coolant
The coolants to be available for selection in the instrument program can be
set in the sub-screen of each individual instrument, see below.
Sub-screen
Used to access additional subordinate functions; see the following function
keys:
Preselect spray coolant
Used to cool and rinse treatment areas
Preselect air coolant
Used to cool and blow clean treatment areas
Preselect NaCl coolant
Used to cool or rinse treatment areas with a sterile saline solution
Instrument light
Activates and sets the instrument light
Direct starter/speed foot control
Direct starter (marked gray): Switches the instrument on with the set speed or
intensity
speed foot control (marked orange): Used to adjust the instrument up to
maximally the set speed and intensity after setting the foot control pedal.
11.4
Treatment program
11.4.1
Treatment selection
Assigning the burr drive
A burr drive must be assigned to each treatment type, i.e. endodontics (left
key) and implantology (right key).
Display of assigned burr drive
The assigned burr drive is marked with an orange circle. Any position marked
with a gray circle also can be assigned.
