61 77 476 D 3495
28
D 3495
.
201.01.02
.
02
08.2007
7
Image acquisition
Sirona Dental Systems GmbH
Positioning the sensor
Operating Instructions and Installation
XIOS USB
7.3
Positioning the sensor
1.
Position the sensor and holder in the patient’s mouth.
2.
Bring the intraoral X-ray unit into position.
7.4
Releasing the exposure
Operating notes
Sensor and USB cables
z
Do not fold or bend any cables.
z
Do not pinch any cables (e.g. in drawers).
z
Do not roll over cables (e.g. with a chair).
z
Do not allow patients to bite the sensor cables.
z
Do not pull on the cable. When unplugging cables from sockets, always
pull the plug only.
Sensor
z
Do not allow patients to bite the sensor.
z
Do not drop the sensor.
Sensor holders
z
The sensor holders are disposable items.
z
Only for the same patient:
The sensor holder can be removed and
reglued repeatedly during a series of exposures, even if it already has
come into contact with saliva.
Exposure
1.
Before taking an exposure, check to make sure that the orange Ready
LED (
B
) of the USB module and the green indicator in the exposure
readiness dialog box of the SIDEXIS XG user interface are flashing.
2.
Take an X-ray exposure (Observe chapter on "Exposure times" [
3.
Remove the hygienic protective sleeve as described in the section
"Removing the hygienic protective sleeve from the sensor" [
4.
Following the X-ray exposure, carefully remove the sensor to prevent it
from falling down. E.g. place the sensor in the wall holder for safekeeping.
5.
Disinfect the sensor if necessary.
6.
Disinfect the guide rod and localizer ring.
7.
Continue with image processing.
NOTE:
An audible alarm is emitted by the PC 5 seconds before the ready to expose
period expires.
