61 77 476 D 3495
34
D 3495
.
201.01.02
.
02
08.2007
8
Use of the X-ray sensor
Sirona Dental Systems GmbH
Parallel technique with radiation limiter!
Operating Instructions and Installation
XIOS USB
X-ray exposure
1.
Position the sensor in the patient’s mouth.
2.
Place the X-ray tube assembly in the correct position. Change the
position of the sensor holder if necessary.
3.
Release an X-ray exposure.
4.
Discard the sensor holder tab and the hygienic protective sleeve
following the patient examination.
5.
The guide rod and localizer ring must be sterilized.
8.3.2
Posterior tooth exposures
Explanation
The "posterior" type sensor holder is available for periapical posterior tooth
exposures.
z
This sensor holder and the matching localizer ring are color-coded
yellow
.
z
The (double-offset) guide rod and the yellow localizer ring for posterior
tooth exposures must be used.
z
The following illustrations show how to attach the sensor holder to the
hygienic protective sleeve with sensor.
Preparation
1.
Plug together the double-offset guide rod
(C)
and the yellow localizer ring
(
B)
of the XIOS holder system for
posterior tooth exposures
.
2.
Select the yellow sensor holder for periapical posterior tooth exposures
and plug it onto the guide rod
(C)
.
3.
Slide the sensor into the hygienic protective sleeve. When doing so,
follow the instructions for sensors.
4.
For the left upper jaw and right lower jaw:
Position the sensor holder
in the middle of the sensor as shown in the illustration. The edge of the
sensor holder must be flush with the edge of the sensor.
