P24
Introduction
4.
變更為其他圖案
⑴按
鍵，縫製
LED
滅燈。
⑵按
鍵，選擇圖案
No.
的項目。
⑶用
、
鍵設定圖案
No.
。
⑷同樣地設定
XY
擴大縮小率、轉速等。
⑸按
鍵之後，縫製
LED
亮燈，成為可
以縫製的狀態。
5.
捲繞底線
⑴邊縫製邊捲繞底線時
:
如圖所示穿線捲繞
底線。
4. Change to the other sewing pattern
⑴
Make the Sewing LED go off with
key.
⑵
Press
key and select the item of
pattern No
.
⑶
Set the pattern No. with
key or
key.
⑷
Similarly, setting of X/Y scale, speed,
etc. is performed.
⑸
When
key is pressed, the Sewing
LED lights up and the sewing machine is
in the sewing ready state.
5. Winding a bobbin
⑴
To wind a bobbin while the sewing
machine is performing sewing:Thread
the bobbin winder and wind the bobbin
thread onto the bobbin as illustrated in
the figure.
選擇圖案後，請一定確認圖案的形狀。
萬一圖案遠離壓腳，縫製途中機針會碰到壓腳，弄斷機針。
Make sure without fail of the contour of the sewing pattern after selection of
the sewing pattern.
If the sewing pattern extends outside the work clamp feet, the needle
will interfere with the work clamp feet during sewing, causing dangerous
troubles including needle breakage.
WARNING
警告
