7
7
6
4
*** For technical support please call 1.800.374.7438 #2007, servicetech@sisergo.com ***
Page: 4 of 5
Elle Series
4-Leg Electric
9. Place control box (4) in cable tray.
10. Connect a network cable (7) to the control box
(4) and then to each network cable port exiting
the leg uprights (1).
11. Connect control switch cable(5) and power
cable (6) to the control box(4), and then power
cord (6) to 120v power outlet.
12. Perform initial reset by pushing the down-button
until the table stops. Push the down-button again
and "hold it" until the legs stop moving.
13. Troubleshooting: Make sure that all cables are
correctly connected to the control box, legs.
control switch, and power source. Perform a new
reset and make sure the procedure has
completely finished before normal operation.
Tools required: Drill driver, PHILLIPS bit PH2. Hex key 4mm.
5
