9
Assembly instructions
Assembly is highly dangerous and must be carried out in strict accordance with the following instructions.
We recommend that qualified personnel perform assembly. We also recommend that assembly be carried out
in a flat, solid surface, open area with no people (particularly children) nearby who could be severely injured
if they were to touch or move any parts of the machine.
Assemblers must provide suitable lifting mechanisms and supports for stabilizing the partially assembled
units, so as to prevent them from falling and causing damage or injury. The steps for assembly are illustrated
in following. Depending on the experience of the assemblers and the tools available, it is not necessary that
the instructions be followed in the exact order given here, but the safety precautions described above must
always be followed carefully and scrupulously.
Assembly sequence:
Fig. 1 - Place the rotor axle (1) in a stable position and then mount the tyres support (6). Use the pivot (8)
and the Seeger circlips (18) to mount support (7) and (12) on to the support so they are facing in the direction
shown in the figure. Use the washer (10) and nut (11) to assemble the wheels with their guards (4) and (5) on
to the tandems. Make sure that, when the wheel brackets (14) are mounted on to the supports (13), the
bracket plate matches the plate divided into sectors for the various supports. Use the screw (15), the nut
(17) and the washer (16) to fasten the wheel bracket into position..
