16
ADJUSTMENT, PREPARATION AND USE
Connection to the tractor is highly dangerous. Take great care and carry out the entire operation in
strict compliance with the following instructions.
Nobody should go near the area between the tractor and the machine.
Check that the tractor is in good running order. Check the engine oil, gearbox oil, brake fluid and
cooling water levels as well as the tyre pressures.
Refer to the tractor operator’s manual.
ATTACHMENT MACHINE TO THE TRACTOR
The attachment of pull-type machines to the tractor is very simple, as it is only necessary to couple
the drawbar hitch (3) to the tractor hitch using a pin of appropriate size, strength and shape. Always
use extreme care when reversing the tractor towards the machine.
The drawbar hitch (3) can be set in different positions, using pin (4) turning the hitch upside-down
from (A) to (B), to allow coupling to all tractor types.
If the two-point crosspiece is used, lock the drawbar hitch (3) using the optional screws (10).
Attention: do not use screws (10) if the machine is hitched to the drawbar.
During transport and working the parking stand (7) must be shifted from position “N” to position
“K”. This is done by removing clip (9) and pin (6) an moving stand (7) out of the parking position.
Fasten parking stand (7) into the transport position using pin ((6) and clip (9).
Once this procedure is completed, insert the quick-release coupling the tractor socket.
