CUTTING
SERIES
EQUIPMENT
CUTTING
SERIES
EQUIPMENT
CAUTION
CAUTION
CAUTION
Do not point the torch jet at foreign bodies.
Av o i d u n n e c e s s a r y l i g h t i n g o f t h e p i l o t a r c t o p r e v e n t e x c e s s i v e
c o n s u m p t i o n o f t h e e l e c t r o d e a n d n o z z l e .
During cutting the speed of the torch movement should be in accordance with the
thickness of the piece to be cut. Excessive speed causes a return of incandescent
towards the torch which shortens the life of the parts of the torch most subject to
wear and tear. The metal fouling on the nozzle should be removed as soon as possible.
power supply
Air compressor
11. Connect air to regulator and adjust regulator to deliver 5-6 bar 90ltr/min
12. Switch the unit on using the main switch located on the back side.
13. press the cutting torch to achieve a pilot from the copper tip, when this pilot is up to the
work piece , cutting operation begins.
Cutting torch
Earth
Clamp
Air regulator installation and operation
1. Firmly tight and seal the copper air hole at IN and OUT terminal by high
pressure rubber tube .
2.Tight and seal the meter with meter face rubber tube.
3.Fix the connecting shelf with screw as the regulator position.
4.Get down the plastic screw and fix the regulator on the shelf.
Operation
Operation
12
13
5.Turn on the air valve, turn up the pressure adjusting knob, turn the pressure
volume (meter inside shows kg), and then put down the knob.(+ means increasing
pressure, -- means decreasing pressure.)
6.Scale of the meter is as follow. The volume in the picture is 6 kg.
7. If the water in thegas filtering bottle is too much, please turn on the water valve to
let the water go out.
Connecting shelf
Pressure adjusting knob
Pressure meter
Air filting bottle
Air pipe
A
ir o
ut
Air in
Drainage interface
